Media Library / Images

AMKI 50 SS, AVKI 50 SS

'Camlock' stainless steel female and male coupling to EN 14420 - 7

LBS 75 hose assembly for foodstuffs, FDA conform

with VC 50 SS male coupling, Spannloc clamps

DGC-V 50 F SS for L.P. Gas, PN 25/40

Dry Disconnect Coupling with flange connection, DN 50, stainless steel, with rubber dust cap

SSB 25 Safety Break: Abriss

Elapharm foodstuff fittings DIN 2817

Slimline 21 red

Quality petrol pump hose for gasoline and diesel fuels. Also suitable for fuels with ethanol content up to E 85 and Biodiesel up to B 30 (BIO Type up to B 100). Meets weights and measures regulations, see overleaf. Cold flexible down to - 30° C / - 22° F (LT-type down to - 40° C / - 40° F). Corresponds to EN 1360 and EN 13483.

VK 80-2" AG Ms

TW male coupling brass, with reduced male BSP connection (special type)

HD-C, underwing nozzle

Aircraft refueller, large reel with aircraft refuelling hose and underwing nozzle

ELAFLEX Hamburg

Assembling Spannloc hose clamps

ZVA 25 with Z-Swivel

Boat Refuelling

TW Couplings with Isolation for electronic Cross-Over Prevention Systems

see Information 4.12

Vehicle refuelling with LPG (L.P. Gas, Autogas)

ZVG 2 ACME nozzle, LPG 16 hose

Hose assemblies for the chemical industry

ERV-GR TA, UTL with DDC, FXD with male thread, Elaflon Plus FEP with foodstuff fitting, Elaflon PTFE with female thrad

VX 50-2" NPT SS

Male hose coupling 2" NPT of stainless steel with Spannfix clamp

SPANNLOC bolted safety clamps of aluminium

SC 75 Al

ERV-G rubber expansion joint

ERV-G AF DN 80, with TW flanges

SD / Pyropal 230 saturated steam hose

M 21-1" NR cr

Female ferrule hose coupling EN 14424, factory assembled, non-reattacheable. Slimline 21 hose, yellow.

Swivels DG 25 SS, DG 38 SS, DG 50 SS with hose assembly

Swivels serve to avoid hose torsion (increase of life span) and help for easier handling

ERV-R 50.16 ZS 2

Red Band Rubber Expansion Joint with "ZS" limiter (tie rods with outer limitation in rubber bushings)

GasGuard GG11R

The GasGuard GG11 Back-Check Valve (GG11R: with additional release screw) should be standard equipment for any LPGas road tanker operator. It is used in conjunction with LPGas bulk refueling nozzles to contain leaks at storage tank fill points. If the fill point proves to be leaking when removing the nozzle it can be left on the tank until corrective action is taken. The driver can move to the next fill point without delay.

Oasis 'Priority Panel' with ball valves for CNG bus refuelling

ERV-GR 80.16 ZS 2

GREEN BAND Rubber Expansion Joint with "ZS" limiter (tie rods with outer limitation in rubber bushings)

DAC-M 65, DAC-V 65

MannTek Dry Aviation Couplings

ELAFLEX Hamburg

Certificate pressure test

ERV-W 80.16

WHITE BAND Rubber Expansion Joint for foodstuffs, also containing oil and fat. Liner corresponds to Recommendation XXI of BfR and FDA-21CFR 177.2600. Not approved for drinking water. Temperature range (depending on medium) - 20° C up to + 90° C, temporarily up to 100° C. Electrically non-conductive.

ROTEX 80.16

Rubber Expansion Joint suitable for permanent use with hot heating water, cooling water and hot air. Approved according to DIN up to 100° C by 10 bar and up to 110° C by 6 bar. Temperature range (depending on medium) - 40° C up to + 130° C, temporarily up to + 150° C. Electrically dissipative

ZVA Slimline 2 without scuffguard: body markings

FHD 50 special type HIFR

(helicopter in flight refuelling)

Oasis BV 708 1" Ball Valve for CNG